Effect of phosphogypsum on saline-alkalinity and aggregate stability of bauxite residue

A column experiment was conducted to investigate the effect of phosphogypsum (PG) on the saline- alkalinity, and aggregate stability of bauxite residue. Results showed that: with increasing leaching time, the concentrations of saline-alkali ions decreased while the concentration increased in bauxite residue leachate; compared with CK (control group) treatment, pH, electric conductivity (EC), exchangeable sodium percentage (ESP), sodium absorption ratio (SAR), and exchangeable Na⁺ content of bauxite residue were reduced following PG treatment; average particle sizes in aggregates following CK and PG treatments were determined to be 155 and 193 nm, respectively. SR-μCT test results also confirmed that bauxite residue following PG treatment acquired larger aggregates and larger pore diameter. These results indicate that the PG treatment could significantly modulate the saline-alkalinity, and simultaneously enhance aggregate stability of bauxite residue, which provides a facile approach to reclaim bauxite residue disposal areas.     

离子型稀土矿山淋洗及尾水富集试验研究

对浸矿后离子型稀土原地浸矿场采用清水进行淋洗，在184天的清水淋洗过程中，尾水氨氮值从最开始的507mg/L，降低至140mg/L，淋洗尾水pH4.52~3.10。淋洗尾水采用两级反渗透膜分离，既回收有价资源稀土，又能使出水氨氮达标。结果表明，产水氨氮浓度稳定低于15mg/L，对稀土的截留率高于98.25%，浓水中稀土离子平均浓度313.4mg/L，可进一步回收稀土资源。     

机械活化对粉煤灰提铝影响研究

为提高粉煤灰中铝提取率, 采用机械活化对粉煤灰进行预处理, 探讨了机械活化对粉煤灰焙烧-酸浸效果的影响。结果表明: 机械活化能提高粉煤灰比表面积、增加反应活性点, 促进活化反应的进行; 通过机械活化, 在Na₂CO₃与Al₂O₃物质的量比1.6、850 ℃下焙烧50 min后酸浸, 铝浸出率达到91.58%。     

A comparative study on the effect of carbon-based and ceramic additives on the properties of fiber reinforced polymer matrix composites for high temperature applications

Ablative composites have been in use for thermal protection of space vehicles for decades. Carbon-phenolic composites have proven to perform exceptionally well in these applications. However with development in aerospace industry their performance needs improvement. In this field, different carbon-based and ceramic additives have been introduced into ablative composite systems. This review article gives a comparative analysis of researches done in this field in the recent past. Density, ablative, thermal and mechanical properties of ablative composites with different ultra-high temperature ceramic particles i.e. ZrSi₂, Cenosphere, nano-SiO₂, BN etc. and carbon-based nanoparticles i.e. CNTs, nano-Diamonds, Graphene oxide etc. used as additives, have been compared and discussed. Emphasis is put on carbon-phenolic composite systems although some epoxy matrix systems have also been discussed for comparison.     

渣油催化临氢热转化钼铁双金属催化剂的研究

Replacement of precious single metal catalysts with cost-effective, highly-dispersed composite catalysts for catalytic hydrothermal conversion of residue holds tremendous promise for the residue upgrading technologies. Organic metals were added to the feed as the oil-soluble precursors, and transformed into the catalytic active phases in this work. Physical properties and structures of the composite catalysts had been investigated by X-ray fluorescence spectroscopy, X-ray photoelectron spectroscopy, X-ray diffraction, scanning electron microscope and transmission electron microscopy. The composite catalysts were found to be highly efficient in the catalytic hydrothermal conversion of both model compound and residue. Increased metal dispersion and synergistic effects of two metals played indispensable roles in such catalytic system. Results showed that under the test conditions in the article, the catalyst had the best catalytic performance when the mass ratio of molybdenum to iron was 1.5.     

分光光度法和光度滴定法联合测定湿法炼锌流程中钴渣浸出液中锌钴镍

湿法炼锌流程中钴渣浸出液中含有高浓度的Fe²⁺和Mn²⁺,用分光光度法测定Co²⁺和Ni²⁺时,Fe²⁺-EDTA会严重干扰Co²⁺和Ni²⁺的测定;在用光度滴定法测定Zn²⁺和Co²⁺合量时,Ni²⁺对二甲酚橙指示剂具有封闭作用,Mn²⁺亦与EDTA螯合,导致滴定结果偏高。为消除Fe²⁺和Mn²⁺对Zn²⁺、Co²⁺和Ni²⁺测定的干扰,实验进行氧化分离Fe²⁺和Mn²⁺预处理,在NaAc/Hac缓冲体系下,以EDTA作显色剂用分光光度法测定Co²⁺、Ni²⁺。在波长466nm处,Co²⁺的线性范围为50~500mg/L时与吸光度呈线性,相关系数R²为0.9992;在384nm处,Ni²⁺的线性范围为50~500mg/L时与吸光度呈线性,相关系数R²为0.9998。根据分光光度法测出Ni²⁺物质的量,加入1.1倍的丁二酮肟以除去Ni²⁺,用二甲酚橙为指示剂,EDTA鳌合-光度滴定法测定Zn²⁺、Co²⁺合量,扣减Co²⁺含量得出Zn²⁺含量。选取4个锌湿法炼锌流程中钴渣浸出液实际样品,按照实验方法中的分光光度法测定Co²⁺和Ni²⁺,光度滴定法测定Zn²⁺、Co²⁺合量,Zn²⁺、Co²⁺和Ni²⁺测定结果的相对标准偏差(RSD,n=6)均不大于0.70%,加标回收率分别为99.59%~100.41%、99.69%~100.64%、99.92%~100.08%。     

铋精矿加压氧化氨浸高效分离铜、硫和铋

针对湖南柿竹园铋精矿火法冶炼过程中存在的成本高、低浓度SO₂和散烟排放污染环境、有价金属综合回收率低等问题, 以柿竹园铋精矿为原料, 提出了加压氧化氨浸分离铋与铜、硫的新工艺, 研究了氨水加入量、浸出温度、浸出时间、浸出压力及浸出液固比等因素对铜、硫、铋浸出率的影响。在氨水用量1.8 mL/g_铋精矿、液固比4∶1、釜压2.8 MPa、浸出温度160 ℃、浸出时间5 h、搅拌速度600 r/min的优化工艺条件下, 铜、硫浸出率分别达93.57%和92.87%, 铋不浸出并以氧化铋形态全部入渣, 实现了铜、硫与铋的高效分离。